1. To begin measure about 1050mm of the floor, this is standard hight. Use a temple guide to mark where the holes will be. ( We use installation Kit here)

2. Once you marked out where the drilling will begin, proceed to do so, we start drilling here on the face of the door.

3. Now continue to do the same for the other side of the door, make sure you are drilling on the markings used from the template.

4. Mark around the faceplate, and proceed to chisel out this section, so the plate is flush with the door.

5. Now you should be ready to fit the latch and barrel in place.

6. Begin to insert the latch.

7. Start to secure it into position by firmly tightening the screws.

8. Follow steps 4/7 to prepare to install the strike plate to the door frame.

9. Secure strike plate into position by firmly tightening the screws.